All the FILSAN separators used in rotary vane or rotary screw type compressors which manufactured domestically or abroad, are produced by using specially and meticilously designed components of highest quality and standards. For this reason, most of the compressor manufactures and their exclusive distributors have a tendency to use the FILSAN products.
Filsan has started producing Separators with the new Technology. Filsan’s newly designed separators has nowelding to combine sepatators body and flange.
These newly designed separators, as shown in Figure, are so designed that they fit the smaller separator housings without reducing the capacity or operating performance of the compressor. When compared to a conventional separator of the same dimensions, these separators have double or even triple capacity. The mentioned increase in capacity is simply achieved by using higher number of wraps in the separators.
With technical capacity and experience Filsan can manufacture and design higher capacity Separators upon O.E.M’s and customer requests.
Separator Types |
Residual Oil content mg/m³ 1to3mg/m³ | Operating Temperature 120°C | Pressure Drop Bar |
Avaible Nominal Flow Rates (at7bar) (0.7Mpa) |
---|---|---|---|---|
Standart Type | ✔ | ✔ | 0,17 | 2 to 42m³/min (special and higher designed separators ara available) |
D-Type | ✔ | ✔ | 0,20 | 3,5 to 58 m³/min (special and higher designed separators ara available) |
Spin-On Type | ✔ | ✔ | 0,25 | 0,9 to 6,5 m³/min (special and higher designed separators ara available) |
FILSAN REF. | Type Nr. |
d1 (mm) |
d2 (mm) |
d3 (mm) |
d4 (mm) |
d5 (Ø) (mm) |
d6 (mm) |
h1 (mm) |
h2 (mm) |
Hole Nr. |
---|---|---|---|---|---|---|---|---|---|---|
FS515 | 1 | 170 | 122 | - | 200 | - | - | 230 | 12 | - |
FS516 | 1 | 170 | 122 | - | 200 | - | - | 435 | 12 | - |
FS530 | 1 | 135 | 88 | - | 170 | - | - | 200 | 12 | - |
FS533 | - | 170 | 122 | - | 200 | - | - | 305 | 12 | - |
FS501 | 2 | 170 | 122 | - | 220 | 13 | 190 | 230 | 12 | 6 |
FS502 | 2 | 220 | 165 | - | 300 | 15 | 266 | 230 | 12 | 12 |
FS508 | 2 | 170 | 122 | - | 300 | 15 | 266 | 305 | 12 | 12 |
FS509 | 2 | 170 | 122 | - | 300 | 15 | 266 | 485 | 12 | 12 |
FS673 | 2 | 170 | 122 | - | 255 | 18 | 217 | 150 | 12 | 8 |
FS518 | 3 | 114 | 66 | 66 | - | - | - | 340 | - | - |
FS521 | 3 | 114 | 66 | 66 | - | - | - | 165 | - | - |
FS636 | 3 | 114 | 66 | 66 | - | - | - | 450 | - | - |
FS670 | 3 | 56 | 25 | 25 | - | - | - | 132 | - | - |
FS807 | 4 | 170 | 108 | - | 200 | - | - | 305 | - | - |
FS808 | 4 | 300 | 220 | - | 355 | - | - | 305 | - | - |
FS809 | 4 | 300 | 220 | - | 355 | - | - | 500 | - | - |
FS581 | 4 | 300 | 220 | - | 350 | - | - | 400 | - | - |
FS551 | 4 | 395 | 330 | - | 440 | - | - | 620 | - | - |
FS506 | 5 | 220 | 155 | - | 300 | 15 | 270 | 350 | - | 12 |
FS510 | 5 | 170 | 108 | - | 300 | 15 | 192 | 175 | - | 6 |
FS511 | 5 | 170 | 108 | - | 300 | 15 | 272 | 230 | - | 8 |
FS656 | 5 | 170 | 108 | - | 300 | 15 | 270 | - | - | 8 |
Air oil separators remove compressor lubricant from the compressed air stream. During normal operation, the compressor lubricant is returned to the oil sump and the compressed air continues to the air receiver. A typical oil separator reduces the lubricant entrained in the compressed air to 0,3ppm. Under normal operating conditions an oil separators service life is 4,000 to 6,000 operating hours (when the flow resistance reaches 1 bar (0.1MPa).
FILSAN REF. |
Flow Rate (m³/min) |
d1 (mm) |
d2 (mm) |
d3 (mm) |
d4 (mm) |
d5 (Ø) (mm) |
d6 (mm) |
h1 (mm) |
h2 (mm) |
---|---|---|---|---|---|---|---|---|---|
FS593 | 9 | 220 | 165 | - | 274 | - | - | 435 | 12 |
FS540 | 12 | 275 | 220 | - | 328 | - | - | 450 | 12 |
FS541 | 14 | 300 | 245 | - | 355 | - | - | 500 | 12 |
FS590 | 17 | 300 | 245 | - | 355 | - | - | 600 | 12 |
FS542 | 19 | 300 | 245 | - | 355 | - | - | 660 | 12 |
FS755 | 20 | 275 | 220 | - | 324 | - | - | 750 | 12 |
FS543 | 24 | 300 | 245 | - | 355 | - | - | 820 | 12 |
FS963/S | 29 | 300 | 230 | - | 355 | - | - | 1000 | 12 |